How to install your led strip light?

How to install your led strip light?,LED strip  light,12V LED strip light,waterproof  led strip  light,Strip light,led strip roll

Step 1:

Decide exactly where you want to permanently fix the LED Tape to give you the best effect you are looking for. This can be under wall corner lighting for example, and from that decision you decide on whether you would prefer the LED Tape near the front or the back of the wall corner.

Step 2:

Measure the LED Tape to the length of the area you are looking to install the LED Tape lights. If the LED Tape is too long you can simply cut the LED Tape with a pair of scissors along the cut point line provided by the manufacturer.

Step 3:

Thoroughly clean the surface down so there is no dust or dirt. If you are sticking the LED Tape to wood it is best if this is sanded down if the wood is rough. Then peel the 3M backing tape from the LED Tape and stick into place. Push down on the LED Tape to make sure it has properly stuck down. Be sure to avoid pushing down on the resistors or this could damage the LED Tape.

Step 4:

Connect the LED Tape to the LED transformer by simply using a connector block to join the cable's together. Some LED Tapes may have a simple DC push connector that you push the female into the male connector. It is also possible to use LED Tape to cable connectors provided by some manufactures。 The transformer can either be plugged into a wall or hard wired to a mains lighting circuit.

TAGED WITH: 120V LED Strip Light, 220V LED Strip Light, 12V LED Strip Light, 24V LED Strip Light, CE LED Strip Light, RoHS LED Strip Light